Application
For an under-sink installation for purified drinking water. Suited for mains pressure installations. low pressure below 30psi requires an additional pump
Description
Keep your drinking water clean and safe with the Hydro Guard™ HDG-45 Series Reverse Osmosis System. It reduces the levels of lead, nitrates, cysts (cryptosporidium, giardia), arsenic, sodium and other contaminants commonly found in unfiltered tap water. The easy to install system offers you quality water at your fingertips 24 hours a day, 7 days a week, 365 days per year. Hydro Guard Quick and Easy SM Cartridges makes filter changes fast, convenient and sanitary. Your family, friends and
The Hydro Guard HDGT-45 is easy to install and requires no tools to change filters, plus it features a 4.5-gallon storage tank.
We recommend adding an Alkaline filter for the best drinking water
Data Sheet
Includes
- Feed water adapter
- Tank ball valve
- Drain saddle
- (already connected to the system)
- Connection tube
- Pre-filter
- Carbon filter
- Membrane
- Post carbon filter
- 1 membrane
- Inline flow restrictor
- Fixed elbow
Performance
NSF58 certification completed & pending
Material safety – chemical extraction
Structural integrity – cyclic and hyrdostatic
Contaminant reduction – Total dissolved solids, VOC, cyst, etc.
NSF/ANSI 58 is the American National Standard for point-of-use (POU) reverse osmosis (RO) systems. It was developed by a joint committee with equal representation from regulators, manufacturers and end users. This standard includes requirements addressing various aspects of these systems, including:
- Safety of materials in contact with drinking water
- Structural integrity
- TDS (total dissolved solids) reduction performance
- Efficiency rating
- Recovery rating
- Contaminant reduction performance
- Information for the end us
- Specifications
- Max inlet pressure 80psi
- Min inlet Pressure 40psi
- System dimensions H x W x D 318 x 12 x 349 (mm)
- System weight 2.7kg
- Tank Dimensions 425 h x 287w (mm)
- Tank capacity 7-12 litres
- Tank weight full 18kg
- Tank pressure should be 8-10psi when empty
- The tank will take 4 -5 hours to fill (flush once before use)
Filtration
STAGE 1 – HDGT-SED5 Sediment Pre-Filter – Removes dirt, sand, rust, and other physical particles. - Replace Every 12 Months
STAGE 2 – HDGT-CB5 Carbon Block Pre-Filter – Removes the chlorine, chloramines, bad tastes, odors, and chemicals - Replace Every 12 Months
STAGE 3 - Membrane Removes up to 99% of the total dissolved solids and contaminants. Replace every 24 months
STAGE 4 – Carbon Post Filter (HDGT-CB5P) – Removes dissolved gases, tastes, and odors from the holding tank water Replace Every 12 Months
We recommend adding an Alkaline filter
Warranty
3-Year Limited Warranty
