Whole-house sediment filtration with flow-activated UV treatment
The Waiora Ultra II Shield combines two stages of sediment filtration with a 48W ultraviolet treatment unit in one covered, wall-mounted system. With two 20-inch jumbo filter housings and a rated flow of up to 45 litres per minute, it offers a practical option for households looking to treat water before it reaches their taps.
From filling the kettle in the morning to running the shower at the end of the day, this system brings filtration and UV treatment together at the point where water enters your home. The protective cover keeps the assembly neatly enclosed, while the included pressure gauge lets you check system pressure at a glance.
Two sediment stages before UV treatment
Each stage has a different job, helping prepare the water for the UV chamber:
- Stage 1: 20-micron pleated sediment filter. Captures larger suspended particles such as dirt, rust and sediment.
- Stage 2: 1-micron polyspun sediment filter. Targets finer particles that pass through the first cartridge.
- UV treatment: 48W ultraviolet lamp. Provides a separate disinfection stage after sediment filtration, without dosing the water with disinfectant chemicals.
UV operation that responds to water flow
A flow switch activates the UV lamp when water moves through the system and switches it off when flow stops. This avoids leaving the lamp running continuously between uses. The unit is rated for a UV dose of 30 mJ/cm² at a flow of up to 45 L/min.
Correct sizing matters: your peak water demand and incoming water quality need to suit the system's operating requirements. UV performance depends on suitable water clarity, correct installation and ongoing maintenance.
Key specifications
- Configuration: two sediment filtration stages plus UV treatment
- Filter housings: 2 × 20-inch jumbo
- First cartridge: 20-micron pleated sediment, Waimana 20PL20
- Second cartridge: 1-micron polyspun sediment, Waimana 20PP01
- UV lamp power: 48W
- Rated maximum flow: 45 L/min
- Rated UV dose: 30 mJ/cm²
- UV control: flow-activated
- Connections: 1-inch / 25mm BSP
- Maximum operating pressure: 8 bar / 116 PSI
- Operating water temperature: 2–40°C
- Power supply: 240V
- Mounting: wall-mounted assembly
- Included features: protective cover and one pressure gauge
Choosing and maintaining your system
This model pairs sediment removal with UV treatment. It should not be selected as a substitute for treatment specifically designed to address dissolved contaminants, hardness, or chlorine taste and odour.
Arrange installation with a suitably qualified installer and allow access for cartridge changes and UV servicing. Replace filter cartridges, service the UV lamp and clean the quartz sleeve according to the manufacturer's instructions and your water conditions. Connecting fittings and bypass valves are not included.
Not sure whether the Waiora Ultra II Shield suits your water supply? Contact NZ Pump And Water Filters with your water source, any available water-test results and your household's water demand. We'll help you work through the right filtration setup and replacement parts.
Recommended for the
Product title
Vendor
$19.99 | $24.99
Product title
Vendor
$19.99 | $24.99
Product title
Vendor
$19.99 | $24.99
Product title
Vendor